![]() | |
|
Volume 1, Issue 5 October 2003 |
|
| |
Basket of Silk RosesMaterials used for this arrangement are - 1. Cut a piece of foam to fit into the basket. It should be large enough to hold the flower stems in position and should stand at least 2.5cm (1") higher than the top of the opening of the basket. The foam can be hot glued in place. If it is a deep basket the base can be filled with crumpled paper first. The foam can be wired in place by bending a long 22 gauge wire in half with equal sized legs to form a long hairpin shape and insert it up through the base of the basket, through the foam and then twist the wires around each other at the top of the foam a couple of times and cut off the excess wire. Another method is to insert a long 22 gauge wire through the top weave of the basket next to the handle, through the foam and out through the opposite edge of the top of the basket. Wind each wire firmly around the start of the handle a couple of times and cut off the excess wire. 2. Cut the silk roses to the desired length. Cut off any excess rose leaf sprays from the roses and place them to one side. 3. The roses can be inserted straight into the foam if the ends
are strong enough. 4. Cover the wire stems with floral tape for about 5cm (2"). 5. Insert eight roses evenly around the edge of the foam to form an oval shape. 6. Insert a rose in the centre and insert four roses evenly around the centre rose. 7. Insert one rose into each end of the foam to sit halfway between the roses at the end of the basket and around the four roses around the centre. Take a spray of three rose leaves, and wire and tape it in the same way as explained for wiring the roses. Repeat this step with the other rose leaf sprays. 8. Fill in between the roses around the edges of the basket with the wired rose leaves to form an oval shape. Fill in between the roses around the top of the basket with the wired rose leaves fanning them out in widening circles. 9. Cut the secondary flowers (hydrangea florets) to the desired length and wire and tape as explained previously and insert evenly between the roses around the edges and in the top of the arrangement. 10. Repeat the above step with the number two filler flowers (freesias). 11. If using dried misty insert this evenly throughout the design. 12. If foam is showing, it can be covered with dry moss or by using extra pieces of foliage (this can be a different type of foliage) placed evenly throughout the design. 13. If using moss, spread it out between your fingers and insert the moss between the flowers and foliage. 14. Make a bow by forming the ribbon into two figure eights, one on top of the other with the bottom two loops a bit longer and wire across the centre of the bow by placing the centre of a 22 gauge wire x 23cm (9") and pull the two wire ends down tight and twist the wires around each other. Insert the bow to the right of the handle and arrange the loops to sit attractively. | |
Display IdeasAn ultra modern display area can be achieved by using a glass and
chrome table and a plain black backdrop. That's it for this time Warm Regards This newsletter is written by Fay Chamoun, who is the Principal of
Floral Art School of Australia and International Floral Design School.
| |
Newsletter InformationPrivacy: Your privacy is very important to us. We will never give your name or e-mail address to anyone for any reason. Copyright: All text and graphics are Copyright © 2003 Fay Chamoun, Floral Art School of Australia and International Floral Design School. You are welcome to forward this newsletter in its entirety to friends and associates. Please subscribe to our Free Floral Design Newsletter. | |